FRITZ!WLAN Repeater 310 Service - Knowledge Base

FRITZ!WLAN Repeater 310 Service
Not your product?
This document is also available for the following products:

Loading the FRITZ!WLAN Repeater factory settings

When you load the factory settings, all of the individual settings you made in the FRITZ!WLAN Repeater are deleted. It makes sense to load the factory settings if you are going to use the repeater at a different location or are planning to pass it on to another user, for example. In addition, this deletes incorrect settings that prevent the repeater from functioning properly.

Loading the factory settings

  1. Plug the repeater in.
  2. Wait until the "Power" and "WLAN" LEDs remain lit or the LEDs of the signal strength indicator flash.
  3. Push and hold the "WPS" button down for about 15 seconds until all of the LEDs flash at the same time.

    Fig.: Loading the FRITZ!WLAN Repeater factory settings

  4. Wait until the factory settings have been completely loaded and both the "Power" and "WLAN" LEDs remain lit.